Wash the foam element using a mild detergent and water.
OPERATING PROCEDURE Stump grinder (SH ) STUMP GRINDER BEFORE USE 1. Read and understand the hazard assessment sheet and safety precaution sheet. 2. Inspect the immediate area and remove any foreign objects from the area. 3. Identify and mark the location of sprinkler heads, gas pipes, telephone cables, electrical cables, etc. stumpclear.barg: example. stump. Slowly lower until cutting wheel contact stump – direct wheel against near-side, top corner and sweep across stump left to right.
Cut approx ½ inch each sweep. Roll machine forward and back as required – remember to reapply lock brake when in position. Do not undercut stump or use bottom of wheel to cut – use front, lower portion. Nov 07, The grinder is positioned over the stump using the proper lifting tools on the grinder.
Once the height and width are correctly set, the grinder is locked into place. The grinding professionals then examine the stump properly before they turn on the grinder. As the grinder runs, spinning blades will contact the wood and grind them stumpclear.barted Reading Time: 5 mins. Operating this Stump Grinder safely is necessary to prevent or minimize the risk of death or serious injury. Unsafe operation can create a number of hazards for you.
Always take the following precautions when operating this Stump Grinder: Your Stump Grinder is a powerful tool, not a plaything.
The safety bail is in the Off position.
Exercise extreme caution at all stumpclear.bar: dbashaw. OPERATING PROCEDURES. Be Sure To Follow All Safety Instructions! Helpful Purple leaf sand cherry shrub pruning (Continued) Be sure brake is adjusted so that locked wheel will not creep while grinding.
On larger stumps, DO NOT allow stump grinder wheels to drop into hole - fill with chips or change position! Just complete stump flush with ground, then go back and cut to Missing: example. Move the machine to the front of the stump and engage the parking brake. Move throttle up to the ENGAGE position. The cutting wheel will begin rotating. Swing the cutting wheel to one side (Figure 10), then lower it approximately 1 to cm (1/2 to 1 inch) into the front-top corner of the stump.
Oct 15, While the grinding blade has some maneuverability, clearance of at least seven feet on one side of the stump is required to allow the grinder to access the area to be ground. In smaller areas with less clearance, it is possible to use our smaller stump grinder, but this can increase the time and cost of the procedure.
The stump grinder is a machine with a large, circular blade or cutter wheel. It is maneuvered into position by one of our arborists, and then it is pressed directly against the stump. The grinding teeth have a carbide sharp tip on the end that pulverizes or grinds the wood fibers in the stump.
Use the lever to place the wheel a few inches above the stump then move the grinder, so the wheel is directly above the front of the stump. You should then turn the wheel and lower it so its 3 inches into the stump.
Using the lever to move the wheel from one side to the other, grind the stump until you are 4 inches into the ground. Jan 16, We rented a stump grinder from home depot for aboutand grinded down a stump from the tree that blew over in the front yard of a neighbors house toda Missing: example.